FREE SHIPPING For orders $35 or more within the USA

Simpson Strong-Bolt® 2 Galvanized Wedge Anchors

(Showing 12 of 26)
  • Customer Reviews

The Strong-Bolt 2 wedge-type expansion anchor has a mechanically galvanized finish for exterior applications where a high-load-resisting anchor is needed. Like the zinc-plated version, it has dual undercutting embossments on each clip segment. These anchors are suitable for horizontal, vertical and overhead applications. The STB2-MG anchor is tested in uncracked concrete in accordance with AC193 and also in uncracked masonry in accordance with AC01.

Key Features

  • Chamfered top designed to prevent mushrooming during installation
  • Suitable for horizontal, vertical and overhead applications
  • Tested for minimum concrete thickness of 3 1/4"
  • Standard (ANSI) fractional sizes: fits standard fixtures and installs with common drill bit and tool sizes
  • Tested per ACI355.2 and AC193

Material

  • Carbon steel

Finish

  • Mechanically galvanized

Installation

  1. Drill a hole in the base material using a carbide drill bit matching the nominal diameter of the anchor to be installed. Drill the hole to the specified minimum hole depth. Using compressed air blow the dust from the hole. (Overhead installations need not be blown clean.) You may also drill the hole deep enough to accommodate embedment depth and dust from drilling.
  2. Assemble the anchor with nut and washer so the top of the nut is flush with the top of the anchor. Place the anchor in the fixture and drive it into the hole until the washer and nut are tight against the fixture.
  3. Tighten to the required installation torque.
Strong-Bolt 2 Diameter (in.) Drill Bit Size (in.) Min. Fixture Hole (in.) Wrench Size (in.) Concrete Installation Torque (ft.-lbf.) 
1/4 1/4 5/16 7/16 4
3/8 3/8 7/16 9/16 20
1/2 1/2 9/16 3/4 45
5/8 5/8 11/16 15/16 60
3/4 3/4 7/8 1 1/8 90

 

Picture for category Mechanically Galvanized
Compare
Show 12 24