Installation Instructions for the Hammer Drive Anchor

Installing Hammer Drive Anchors can be completed in four simple steps. Hammer Drive Anchors can be used in concrete, brick and block base materials, and are best suited for light duty fastening. Hammer Drive Anchors are available in 3/16” and 1/4" diameters, and up to 3” long. The hole diameter required for a Hammer Drive Anchor is equal to the diameter of the anchor. The Hammer Drive Anchor is tamper and corrosion resistant. Simple step-by-step installation instructions for the Hammer Drive Anchor are as follows:

1. Using a hammer drill and a properly sized carbide tipped drill bit, drill a hole in the base material 1/4” deeper than the expected embedment of the Hammer Drive Anchor.

2. Clean out hole of all debris.

3. Insert the hammer drive anchor through the hole in the fixture and into the hole in the base material.

4. Using a hammer, hit the nail into the hammer drive anchor until the head is flush with the top of the anchor.

---

 

© Concrete Fasteners, Inc. All Rights Reserved.
521 S. Court St. Medina, Ohio 44256
Phone: 800-966-9617 | Fax: 888-498-4985