Concrete Anchors & Fasteners is Our Specialty   Questions? Contact Mike   

You have no items in your shopping cart.
Free Shipping
For orders $25
or more within
the USA

1/4" Tire Wire Spike, 100/Box

$80.44 per Box of 100
    Payment types
   Availability: In Stock
  Questions? Email Mike

SKU: STW14;P MFG#: 3759
  MFG: Powers


Powers - 1/4" Tire Wire Spike

These anchors come packaged with 100 pcs per box and are designed for fastening items to concrete.

  • Bit size 1/4"
  • Minimum embedment 1-1/8"
  • Zinc plated for indoor use
  • Do not use in vibratory loads
  • Packaged with zinc plated nuts and washers
  • 1/4" inch diameter x inch long
  • Spacing must be a minimum of 10 anchor diameters
  • Free freight on all orders over $25.00
Products specifications
Bit Size 1/4"
Minimum Embedment 1-1/8"
2000 PSI Concrete - Shear (lbs.) * 1585
Type Male
Primary Concrete only
Diameter 1/4"
Material Carbon Steel Zinc Plated
Environment Dry
Box Qty 100
Minimum Spacing See PDF
Minimum Edge Distance See PDF
Minimum Fixture Hole Diameter (In Place) 5/16"
Length Measurement Underneath head
Brand Name Powers

Applications
The anchor is made from Carbon Steel, and is zinc plate. This anchor is designed for use in Concrete only, and should never be used in block or brick base material.

Environment
The anchor is designed for use in a dry environment.

Head Style
The anchor is a Tie Wire head and is designed to allow the head to sit on top of the surface of the item being attached.

Hole Diameter/Bit Diameter
The anchor requires a 1/4" hole to be drilled in the base material (Concrete only). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.

Diameter of Anchor
The diameter of the anchor is 1/4".

Minimum Embedment
The minimum anchor embedment into the concrete is 1-1/8". Therefore, the anchor must be installed so that a minimum of 1-1/8" of the anchor is embedded into the concrete.

Depth of Hole
The depth of the hole that is required for the anchor should be a minimum of 1/2" deeper than the anchor will penetrate the concrete. This will allow space for dust created during the installation process to fall, which will prevent the anchor from bottoming out in the hole before full penetration into the concrete.

Fixture Hole Diameter
The hole in the fixture or material being fastened must be larger than the designated diameter of the anchor. The 1/4" diameter anchor requires the hole in the fixture to be 5/16".

*
*
*

Product/Company Reviews

* The figures above indicate average ultimate tension and shear failure values. A safety factor of 4:1 or 25% of ultimate value is generally accepted as a safe working load. Reference should always be made to applicable codes.



* The bits are recommended by diameter and may not necessarily be the length needed for your application. Please make sure the usable length will work for your application. *

These bits work with the selected anchor
Back to product