The anchor is made from 304 Stainless Steel. This anchor is designed for use in Concrete, Block, and Brick.
The anchor is designed for use in a Wet environment.
The anchor is a Acorn/Open head and is designed to allow the head to sit on top of the surface of the item being attached.
Hole Diameter/Bit Diameter
The anchor requires a 1/4" hole to be drilled in the base material (Concrete, Block, and Brick). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.
Diameter of Anchor
The diameter of the anchor is 1/4".
The length of the anchor is 2-1/4"
The threads on the anchor are national coarse threads that measures 1/4" with 24 threads per inch, commonly referred to as 1/4"-24 .
The anchor is packaged with 100 pieces per box and comes assembled with open acorn nut and washer.
The minimum anchor embedment into the concrete is 1". Therefore, the anchor must be installed so that a minimum of 1" of the anchor is embedded into the concrete.
Depth of Hole
The depth of the hole that is required for the anchor should be a minimum of 1/2" deeper than the anchor will penetrate the concrete. This will allow space for dust created during the installation process to fall, which will prevent the anchor from bottoming out in the hole before full penetration into the concrete.
Maximum Fixture Thickness
The maximum fixture thickness or the maximum thickness of the material being fastened for a anchor is 1-1/4". This will ensure that the minimum embedment of 1" will be met.
Fixture Hole Diameter
The hole in the fixture or material being fastened must be larger than the designated diameter of the anchor. The 1/4" diameter anchor requires the hole in the fixture to be 5/16".
The size of the wrench required to turn the nut to set the anchor is 7/16".
To be set properly in the concrete, the anchor must be torqued to between 2 - 6 ft./lbs.
Spacing between Anchors
Each anchor must be spaced a minimum distance of 2-1/2" from each other when measured center to center.
Edge DistanceHolding Values - Ultimate Load Values in 2000 PSI Concrete
It is very important not to install the anchor any closer than 1-1/4" from an unsupported edge of the concrete.
1/4" x 2-1/4"