Description
Products Features
- No pre-drilling required – self tapping screw save time of installation
- Install in center of wood member provides best opportunity for highest holding values
- Fast Installation – save time from traditional methods
- Special nut driver – prevents shearing of fastener saving time and money
- One piece design – reduces installation cost
Products specifications
| Box Qty | 100 |
| Diameter | 1/4" |
| Length | 2" |
* Values shown are average ultimate values and are offered only as a guide and are not guaranteed. A safety factor of 4:1 or 25% is generally accepted as a safe working load
Diameter of Anchor
The diameter of the anchor is 1/4".
Length Anchor
The length of the anchor is 2"
Installing a 3/8" CONFAST Threaded Rod Anchor for Wood, Vertical, 1/4" x 2"
- Insert the correct nut driver into a 3/8” or 1/2” drill motor.
- Insert the CONFAST® Threaded Rod Hanger into the nut driver.
- Push the fastener vertically into the surface of the base material while the drill rotates.
- Installation is complete once the nut driver spins freely. Nut driver is designed to cam out once the fastener is secured.
Note:
- Minimum Size of Wood Member not less than 2" nominal wide and 3" nominal height
- Maximum RPM for installation is 1200. Do not install the fastener while the drill motor is in the hammer or impact mode, doing so will Destroy holding values.
Extra Information
Brand:
CONFAST®
Box Qty:
100
Diameter:
1/4"
Length:
2"
__ProductType:
MHEA
