Simpson Strong-Tie - 5/8" x 6" Simpson Strong-Tie Titen HD Screw Anchor 304 Stainless Steel (ea) THDB62600H4SS
These anchors come packaged with 10 pcs per box and are designed for fastening items to concrete.
Bit size 5/8"
Minimum embedment See PDF
Do not use in vibratory loads
5/8" inch diameter x 6" inch long
Spacing must be a minimum of 10 anchor diameters
Free freight on all orders over $25.00
Products specifications
Bit Size
5/8"
Minimum Embedment
See PDF
Box Qty
10
Thread Type
Undercut Design
Type
Male
Diameter
5/8"
Length
6"
Material
304 Stainless Steel
Environment
Wet
Minimum Spacing
See PDF
Minimum Edge Distance
See PDF
Maximum Fixture Thickness
See PDF
Minimum Fixture Hole Diameter (In Place)
3/4"
Minimum Fixture Hole Diameter (Hole Spotted)
3/4"
Maximum Torque
See PDF
Wrench Size For Nut
15/16"
Length Measurement
Underneath head
Brand Name
Simpson Strong-Tie
* Values shown are average ultimate values and are offered only as a guide and are not guaranteed. A safety factor of 4:1 or 25% is generally accepted as a safe working load
Applications The anchor is made from 304 Stainless Steel, and is 304 Stainless Steel. This anchor is designed for use in
Environment The anchor is designed for use in a wet environment.
Head Style The anchor is a Hex Washer Serrated head and is designed to allow the head to sit on top of the surface of the item being attached.
Hole Diameter/Bit Diameter The anchor requires a 5/8" hole to be drilled in the base material (). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.
Driver Required A 15/16" is required for driving the anchor into the base material.
Diameter of Anchor The diameter of the anchor is 5/8".
Length Anchor The length of the anchor is 6"
Packaging The anchor is packaged with 10 pieces per box .
Depth of Hole The depth of the hole that is required for the anchor should be a minimum of 1/2" deeper than the anchor will penetrate the concrete. This will allow space for dust created during the installation process to fall, which will prevent the anchor from bottoming out in the hole before full penetration into the concrete.
Fixture Hole Diameter The hole in the fixture or material being fastened must be larger than the designated diameter of the anchor. The 5/8" diameter anchor requires the hole in the fixture to be 3/4".
Wrench Size The size of the wrench required to turn the nut to set the anchor is 15/16".
Torque Value To be set properly in the concrete, the anchor must be torqued to between See PDF
Installing a 5/8" x 6" Simpson Strong-Tie Titen HD Screw Anchor 304 Stainless Steel (ea) THDB62600H4SS
Drill a 5/8" hole into the concrete using a carbide-tipped bit that meets ANSI Standards B212.15.
Drill the hole a 1/2" deeper than the anchor will penetrate the concrete, making sure the minimum embedment requirements of See PDF is met.
Clean the hole with a wire brush, vacuum, compressed air, or a blow-out bulb.
Insert the point of the 5/8" x 6" Simpson Strong-Tie Titen HD Screw Anchor 304 Stainless Steel (ea) THDB62600H4SS into the hole. Make sure that the screw being installed will penetrate the base material a minimum of 1" but no deeper than 1-3/4".
Turn the screw clockwise, applying slight pressure until the head of the screw is snug against the material being fastened.
Always use proper personal protective equipment per manufacturer's and OSHA instructions.
