Sammys® 3/8" Vertical Threaded Rod Anchor for Steel, 3/8"-16 Rod Size, 1/4"-20 x 1" Screw Size - DSTR 1 - 8038957, 25/Box

Sammys® 3/8" Vertical Rod Anchor for Steel, 3/8"-16 Rod Size, 1/4"-20 x 1" Screw Size - DSTR 1 - 8038957

• Teks Drill Point technology delivers one step installation process
• No predrilling required
• Reduces installation time and cost

• Threaded rod attachment
• Allows specifiers and designers to engineer systems with fewer attachment points
• Holds from 446-3125 lbs.

• Installs with SAMMYS Nut Driver
• Ensures correct installation torque
• Reduces occurrences of fastener failure due to over driving

Warranty requires the use of the appropriate nut driver for installations.

Installation

1. Insert the appropriate nut driver into a 3/8" or 1/2" portable drill.

2. Insert the Sammys® into the #14 (black) nut driver (p/n 8113910). Drill should be in a vertical position.

3. Push the face of the nut driver tight to the member. Begin installation when the nut driver spins freely on the Sammys®, stop drill and remove.

4. The Sammys® is now ready to receive 1/4", 3/8", 1/2" or metric all thread rod, bolt stock (The 1/2" requires the #14SW (red) nut driver).

When installing DSTR, follow the above instructions, then add retainer nut and torque to 20 foot lbs. for maximum pullout in purlin steel.