Sammys® 1/2" Vertical Threaded Rod Anchor for Light gauge steel, 1/2"-13 Rod Size, 3/8" x 1" Screw Size - DST 2.0 - 8031925, 25/Box

Sammys® 1/2" Vertical Rod Anchor for Metal Deck, Purlin or Tubular Steel, 1/2"-13 Rod Size, 3/8" x 1" Screw Size - DST 2.0 - 8031925

• Two step installation process
• No custom bracket assembly required
• Reduces installation time and cost

• Attachment angle from 1-89 degrees
• Attaches to angled steel elements, bottom or side of steel elements
• Provides more attachment locations for designers and specifiers

Installation

1. Insert the bit receiver with 25/64” drill bit into the chuck of a min 18-volt battery operated drill and drill a 25/64” hole through the purlin at the desired location.

2. Slide the sleeve of the X-Press It over the drill bit until it connects to the receiver.

3. With the internally-threaded portion of the anchor (SXP 20, SXP 2.0, SXP 35, & SXP 3.5) positioned inside the socket of the installation tool, secure the square base of the Sammy X-Press Swivel within the square recessed guidelines of the installation tool.

4. Insert the Sammy X-Press Swivel anchor through the pre-drilled hole.

5. Install the Sammy X-Press Swivel anchor to release the expandable portion of the anchor and secure the anchor in the metal deck or purlin to allow vertical orientation of threaded rod.

Important Note: Warranty requires the use of the appropriate Sammy X-Press It® Tool for installations.